Hello to all of you who are visiting looking at 3D Modelling and 3D Printing for information hungry kids out there following our recent lessons.
Below you will find a link to five of the programs intended for younger or inexperienced people to get into 3D Modelling. Please follow the link and the one we used in our inputs was ” TinkerCad “.
You may find that one of the others actually turns out to be more intuitive for you or your youngster, so please do try them rather than deciding its just too hard to do.
Here’s the Link 🙂
Good luck and I suggest a simple one or two block design first, not their favourite cartoon hero. That can come later…. easy first steps…then we can work from there…lots of praise and as few tears as possible 🙂